KOMPAS-3D v24

This dialog appears when removing the bend table from the part.

It contains a list of bends, which are part of the sheet elements with automatically detected bend angles, and which include the definition of parameters by source item.

The elements with automatically detected bend angles are:

•sheet solid with an open sketch (bend angles are defined by the parameters of the sketch objects),

•an incision, the specified size of which is less than the minimum (bend angles are calculated by the system).

In the Bend Selection dialog, specify the bends for which you want to save the flat pattern value obtained from the table. To do this, enable the option in the required lines of the list.

The All at the top of the list option allows you to select or deselect all folds in the list. This option can have one of three states:

•enabled  — all options in the list are enabled,

•not defined  — the list contains both enabled and disabled options,

•disabled  — all options in the list are disabled.

If the option's state is not defined, clicking on the option will disable it, and clicking again will enable it.

Once you have completed selecting the folds, click the Apply button.

For selected bends, the determination of parameters based on the source object will be automatically disabled. The method for determining the flat pattern length will change to the method corresponding to the type of table used. The flat pattern parameter for each fold will take the value selected from the table, taking into account the angle of that bend.

The remaining bends will retain determination of parameters by source object. Therefore, each of them will get the same parameters as the source object regardless of the bend angle.

Cancel button of the bend selection dialog allows you to refuse deletion of the bend tables.