|
Tangent |
Scroll |
Tangency of selected curves is set using the Tangent 
.
Step-by-step instructions
1.Specify two curves you want to set as tangent.
|
When working with a drawing please note that all the parameterized objects must belong to the same view. |
If the existing constraints do not prevent tangent of the specified objects, then the image will be rebuilt, and after that these objects (or their continuations) will become tangent. One object may have several constraints applied: constraint Tangent.
|
When applying the Tangent constraint to a spline, please note the following features: •the point of the spline tangent with another curve is the point in which the spline was specified, •if the point of tangent is required to be the final point of the spline, before applying the constraint you should place this point on the curve which should be tangent with the spline (applying the constraint point on the curve is not mandatory). |
2.To complete the command, click Finish 
.
Additional features for applying constraints...
The Tangent constraint can be automatically applied when constructing objects in parametric mode. To do this, the Tangent option must be enabled in the Parameterize list when setting up parametric mode. The parametric mode setting is performed for a graphic document in the section Parametrization of setting dialog box, and for the sketch in the model — in the section Sketch. The limitation will arise when constructing (in any way) tangent objects.
Constraints are displayed in the graphic area in the constraint view mode. Tangent is indicated by a symbol
.
See Also
