KOMPAS-3D v23

Navigation: 9.KOMPAS-3D Settings > Current document parameters > Text Document > Text Styles

Table Header

Text parameters of the table header in a text document are set up in the dialog Text parameters of Table Header, fetched by the command Setup — Parameters... — Current text document — Text styles — Table header.

A similar dialog is used when setting up:

•a table header in the graphic document,

•a table cell in a text or graphic document,

•report table header,

•report table cells,

•captions in the model,

•Table header in model,

•table cells in model.

Controls of the dialog for setting up the document text

	The element	Description of setting
	Line Spacing, mm	A field to enter the distance between the lines of text in a paragraph. Change of spacing allows for saving proportionality of distances between the lines, typed font of various symbol height (for example, when adding footers, comments, or notes into the text which were typed in a font much finer than the font of the main text).
	1st line indent, mm	A field to enter the first line of paragraph. The indentation is measured from the text border. While creating a new paragraph, the cursor is automatically set into a position with a present indent.
	Indentations	Fields to input distances between the left and right borders of the input field and the respective text boundaries.
	Spacing	Fields to set distances between two neighboring paragraphs. This distance is a sum of two quantities – spacing after paragraph of the first paragraph and the spacing before the second paragraph. Setting spacings allows for selection of paragraphs in a text document for their best comprehension while reading, as well as for attraction of attention to especially important information.
	Alignment	These options allow for selection of the required method to align paragraphs (by the left-hand boundary, by the right-hand boundary, alignment by two boundaries).
	Font...	A button to fetch a dialog for setting font parameters.
	Tabulation...	A button to fetch a dialog for setting tabulation parameters.

On completion of the paragraph parameters set-up, press the OK button. Click Cancel to discard all changes and close the dialog box.

Please enable JavaScript to view this site.

KOMPAS-3D v23