|
BOM name on sheet |
Scroll |
Parameters of the BOM name on the sheet for the current drawing are configured in the Settings of BOM name on sheet dialog, invoked by the command Setup — Parameters... — Current Drawing — Document Parameters — BOM Name on the Sheet.
The dialog allows to configure the default text settings of the BOM name (see section BOM name in the drawing) and the distance from the BOM table to the name.
Controls of the dialog for setting up the BOM name on sheet
The element |
Description of setting |
|
Line Spacing, mm |
The field allows setting the distance among the lines of text. |
|
1st line indent, mm |
The field allows setting the value of indentation to the right of the paragraph boundary in its first line. |
|
Font... |
A button to fetch a dialog for setting font parameters. |
|
Tabulation... |
A button to fetch a dialog for setting tabulation parameters. |
|
Indentations |
The group of fields allows for setting a value (in millimeters) of paragraph indentations from the left and right. Borders of paragraphs of the BOM name are vertical lines on which the right and left borders of the BOM table lie. From these lines, counted are indentations from the left, from the right, and a line indent. In other words, the maximum width of paragraph of the name is equal to the width of the BOM table. |
|
Spacing |
The group of fields allows for setting a value (in millimeters) of spacing before paragraph and after paragraph. |
|
Alignment |
The group of fields allows for selection of the required method to align paragraphs (by the left-hand boundary, by the right-hand boundary, alignment by two boundaries). |
|
Distance to specification, mm |
The field allows to set the distance between the BOM name and the upper border of the BOM table. |
On completion of the set-up, press the OKbutton. Click Cancel to discard all changes and close the dialog box.
