KOMPAS-3D v23

Unified parameters of bends

The Unified/Individual switch, located in the Bend Parameters group, allows the application of the same parameters to all bends in the created sheet solid.

Bends in the sheet solid and their corresponding parameters are displayed in the Bend parameters table. If the switch is set to the Unified position, the table cells will have a gray background and will be non-editable.

If you want to set the parameters separately for each bend, set the switch to Individual. Table cells will become available for editing, and their background will change to white.

To change the parameter value, click in the corresponding cell of the table and enter the value, or select the relevant option from the list that appears.

If the bend matches the fillet in the source model, then the bend radius is the fillet radius. Cells Setting radius and Radius for such bends are not available for editing.

Unified parameters of corners capping

The Unified/Individual switch located in the Angle Parameters group allows you to apply the same closing parameters to all angles between adjacent bends in the created sheet solid.

If you need to set the capping parameters separately for each corner, set the switch to Individual. The table Corners with a numbered list of angles will appear on the Parameter Panel.

The table contains the following parameters of angles:

•gap value,

•capping method,

•angle processing method,

•hole parameters: location, diameter, offset (cells are available if the circular angle processing is selected).

Each table row contains the parameters of a single capped angle. Parameter cells are available for manual entry.

When a row is selected in the table, the capped sides of the corresponding angle will be highlighted in the graphic area.

To change the angle capping parameters, click in the corresponding cell, then select the relevant option from the list or enter a value.