|
Arrows and Obliques |
Scroll |
Setup of display of arrows and obliques of dimensions for a graphic document is performed in the Arrows and Obliques dialog, invoked by the command Setup — Parameters... — Current drawing/fragment — Dimensions — Arrows and Obliques.
Similar dialog is used at setup of drawing of arrows and notches of the sizes for models.
Controls for the dialog of draw settings of arrows and obliques
The element |
Description of setting |
||
|
Arrows Location |
To select a variant of location of arrows for dimensional lines relative to extension lines of a dimension, enable the required option: From inside, Outside, Auto. The Auto option means that the system will automatically determine whether to put arrows outwards or outside for each dimension. |
2.1 |
Dimension line arrows |
To make dimension line arrows filled, enable the Fill arrowsoption. If the option is disabled, the arrows are drawn as lines. Change of the state of the option is expressed in the example of an arrow. The setting of filling extends to the following objects: •all dimensions with arrows of the following types: “Arrow”, Solid Arrow”, “Point”, “Point - Small”; •geometric tolerance designations; •view direction arrows, •surface finish designation on the leader landing. |
1.1 |
|
Obliques |
To make obliques be redrawn by main lines, enable the Normal option. If the option is disabled, obliques are drawn as thin lines. Change of the state of the option is expressed on the example of obliques. Setting of the drawing of obliques extends to all the objects which have (or may have) obliques in its structure: •dimensions with arrows in the form of obliques; •surface finish designation on the leader landing. |
1.1 |
After you complete configuration of the drawing of arrows and obliques, click the OK button. Click Cancel to discard all changes and close the dialog box.
