|
Node and Sectional Node Point Designation – General Settings |
Scroll |
General settings of sectional node point designations for the current graphic document are made in the General settings dialog, invoked by the command Settings — Parameters... — Current drawing/fragment — Designations for Construction — Node and node section designation — General settings.
The dialog allows to select the styles of hatch line, to indicate if hatches should be connected with a line, and select the style of this line. For more convenience of work, figures explaining the selection of parameters are included into the dialog.
Controls of the dialog for setting up node point designations
The element |
Description of setting |
||
Dash line style |
The group of options allows to select the line style for drawing the dash – Normal or Thick. Switching of options is expressed in the explanatory figure. |
1.1 |
|
Line between dashes |
The group of options allows for selection of the style for drawing a line between dashes – Thin or Dash Dot, as well as to disable drawing of a line, by selecting the Do not drawoption. Switching of options is expressed in the explanatory figure. Note that the line is not drawn if the distance between dashes is less than the doubled value of the gap specified in the dialog for configuring the parameters the of node point designation (see section Node and sectional node point designation – Parameters). |
1.1 |
On completion of the set-up, press the OKbutton. Click Cancel to discard all changes and close the dialog box.
