|
Managing the BOM Table Position in a Drawing |
Scroll |
Changing the Default Location of the Table
To set up the BOM table location, you can use the following commands:
•Management — BOM — BOM on Sheet — Location.
This command activates placement of the current style BOM.
•Place BOM from the table context menu.
This command activates placement of the BOM for which it is run.
After running any of these commands, the dimensional frame of the BOM table and defining points in the corners of the table appear on the screen. If the BOM is split into several sheets,then each sheet is a separate table; in this case, the points appear in the corners of each table.
There are two ways to place a table:
•Arbitrary
Place the cursor on the table; it will become a four–headed arrow. Press the left mouse button and move the mouse. When the phantom of the dimensional frame of the table reaches the desired position, release the mouse button.
Besides, you can drag and drop any of the defining points of the table. In this case, you can use snaps to specify the position of the table.
•With specifying coordinates
Click any of the defining points of the table, then enter the coordinates of this point in the Current Point field on the Parameter Panel.
Position the table as required, then click Finish 
button in the Parameter Panel header.
Restoring the Default Location of the Table
To restore the default location of the BOM, i. e. to align the right bottom corner of its table with the right top corner of the title block on the first sheet of the drawing, run the Auto Locate command from its context menu.
