|
Break line |
Scroll |
Default parameters of view break lines in the current drawing are set up in the Parameters of break line dialog, which is invoked by the command Setup – Parameters... — Current drawing — Break line.
Controls of the dialog for setting up parameters of break line
The element |
Description of setting |
||
Break line type |
The group of options allows to select the break line type which will be used by default during creation of breaks of views. |
2.1 |
|
Waves line amplitude as % of length Amplitude, max |
Fields for configuring a wavy line or a line with bends. More details on parameters of wavy line and jogged line... |
2.1 |
|
Gap |
A field for entry or selection of the distance between the break lines – the distance at which the visible parts of the image after creation of a break will be located one from another. The minimum value of gap – 1 mm. |
2.1 |
|
|
When using break lines with bend, the gap should be at least two amplitudes. Therefore, if the default gap is less than the doubled maximum amplitude, then during creation of a break limited to lines with a bend, the default value of the gap automatically increases. |
||
Having completed setup of the parameters of break line, press the OK button. Click Cancel to discard all changes and close the dialog box.
The setting done in this dialog is stored in the document itself and does not change upon its transfer to another workplace.
