|
Mark/Reference Designation — On Line |
Scroll |
Parameters of marks/reference designations on line for a current graphic document are set in the Mark/reference symbol settings dialog opened using the Settings — Parameters... — Current Drawing/Fragment — Designations for Civil Engineering — Mark/Reference Designation — On Line — Parameters command.
The dialog allows for setting distances from the text to the line below/above it. The configurable parameters belong to subgroup 1.1 (see section Types of Object Parameters).
For more convenience of work, an explanatory figure is included into the dialog.
|
If during creation of a mark/reference designation, two-line text is entered and the method of its placement is set to On Line, then the interline spacing will be equal to the sum of distances from the upper and lower text lines to the line. |
Enter the required values of parameters into the fields of the dialog or select them from the dropdown lists. The entered values are added to the list and saved within the session of KOMPAS-3D.
Upon completion of the draw parameters, click OK. Click Cancel to discard all changes and close the dialog.
Parameters of text on line for marks/reference designations for a current graphic document is performed in the Mark/reference symbol's text parameters dialog opened using the Settings — Parameters... — Current Drawing/Fragment — Designations for Civil Engineering — Mark/Reference Designation — On Line — Text command.
The procedure for a similar dialog is described in section Caption.
