|
Parameters of center and center grid designations |
Scroll |
Parameters of designation of the center or grid of centers are set in the Parameters sector of the Parameter Panel. See the table for description of elements.
Controls of the parameters for the center mark
Item |
Description |
|
Jut |
The field for input of the value of protrusions of centerlines beyond the boundary of the datum object. |
|
Dash Length |
The field to enter the value of the dash length. |
|
Spacing |
The field to input the value of distance between a dotted line and the hatch. |
|
|
According to GOST 2.303, the total dash length and two gaps should be 3…5 mm. |
|
Specify hatch length |
The toggle switch allows to set the maximum length of hatches of centerlines. To specify the hatch length, set the toggle switch to position I (enabled). On the Parameter Panel, there will appear the Maximum dash length field to input the value of length. |
|
Maximum Dash Length |
The field to input the value of the maximum length of hatches of the centerlines. Is present on the Parameter Panel, if the Specify hatch length toggle switch is set to position I (enabled). If the maximum value of length of a hatch is set, then requirements of the standard are not taken into account. The length of hatches is calculated so that the resultant value does not exceed the indicated value. |
|
Cross size |
The field to input the value of length of hatches which form a crosshair. Available in the Center mark. The field is present on the Parameter Panel during creation of the center mark in the form of a "cross". In all other cases, the length of central hatches is determined by the system automatically. |
|
Lengths of elements of lines for the center mark do not depend on the scale of a view, i.e. are set "for paper". |
