|
Parameters of coordinate axis |
Scroll |
Parameters of coordination axis are configured using the elements located in the Additional parameters section. The description of these elements is provided in the table.
Controls of parameters of the coordination axis
Item |
Description |
|
Dash Length |
Field to enter the value of the dash length. |
|
Spacing |
The field to enter the distance between a dotted line and a hatch. |
|
Specify hatch length |
The toggle switch allows to set the maximum length of hatches of the line of coordination axis. •If the toggle switch is set to 0 position (disabled), then the hatch stroke length is calculated automatically. Its value is in range 5...30 mm. •If the toggle switch is set to I position (enabled), on the Parameter Panel there is the Maximum dash length field for input of the length value. The length of hatches is calculated so that the resultant value does not exceed a preset value. On building a coordination axis, the following conditions are met: •The axis starts and ends with hatches. •The starting and final points of an axis are placed on hatches. |
|
Maximum Dash Length |
The field for setting the maximum length of hatches of the coordination axis. Is present on the Parameter Panel, if the Specify hatch length toggle switch is set to I position (enabled). |
The default values for the ring diameter and width are set in the Coordination Axes — General Settings subsection, while the selection of the axis line construction method and the default parameter settings are specified in the Coordination Axes — Parameters subsection of the current document settings dialog.
