|
Release angle |
Scroll |
You may want to delete parts of adjacent bends when creating bends.
|
Example of bend location that allows to release the angle:
a flat ring face of the created Bend 1 partially coincides
with a flat rectangular face of the adjacent Bend 2
Bend relief is set in the Release section.
To select the required method for bend relief, use the Method group of buttons.
Methods of corner relief and their results are given in the Table.
Methods of corner relief
Corner relief method |
Result of plotting (shown for Bend 1, see Figure above) |
|
|
Only bend |
|
|
Bend and its extension |
|
|
All Bends |
|
You can use the Only Bend relief method to delete portions of the bends that join edges of the chain.
|
|
a) |
b) |
Bend along the chain of edges joined by bends
a) without corner relief, b) with corner relief
|
While using the Bend releasing the angle is only possible if the line of the created bend is perpendicular to the lines of the adjacent bends. |
