|
Normal To... Orientation |
Scroll |
To rotate the model, at which the specified plane or flat face of the model becomes parallel to the screen plane, use the Normal to... 
command.
Step-by-step instructions
1.Specify the required flat object:
•a flat face,
•a coordinate or constructive plane,
•a sketch (it should be specified in the Design Tree).
|
You can select a flat object before running the command. |
The model will turn so that the view direction is perpendicular to the selected object. A minimum angle to turn the model further to the required position will be selected automatically.
If the Normal to... command is called once again, the model will rotate so that the reverse side of the specified flat object is facing the observer.
|
In the Sketch mode, the plane for the Normal to... command does not need to be specified. Immediately after the command is called, the model is turned so that the plane of the edited sketch is parallel to the screen. |
See Also
