KOMPAS-3D v23

This dialog appears when removing the bend table from the part.

It contains a list of bends, which are part of the sheet elements with automatically detected bend angles, and which include the definition of parameters by source item.

The elements with automatically detected bend angles are:

•sheet solid with an open sketch (bend angles are defined by the parameters of the sketch objects),

•an incision, the specified size of which is less than the minimum (bend angles are calculated by the system).

In the Bend Selection dialog, specify the bends for which you want to save the flat pattern value obtained from the table. Click OK.

Determination of parameters by source object will be automatically disabled for the selected bends. The method for determining the flat pattern length is automatically changed to a method matching the type of the table used. The flat pattern parameter for each bend will take a value selected from the table based on the angle value of this bend.

The remaining bends will retain determination of parameters by source object. Therefore, each of them will get the same parameters as the source object regardless of the bend angle.

Cancel button of the bend selection dialog allows you to refuse deletion of the bend tables.