|
Exporting models to JT format using the commands |
Scroll |
Exporting models to JT format can be performed using the File — Save as... command and the File — Export command.
Exporting a model to JT format using the File — Save as... command allows you to export the model with the current export settings.
The File — Export command is typically used in cases where specific export parameter settings are required. For example, if you only need to view the models, then you can transfer only triangulation to the JT format file, and if you need to work with the geometry, then an exact representation shall be transferred too.
To do this, run the File – Save as...command.
Step-by-step instructions
1.Open or create a model in KOMPAS-3D (part or assembly).
2.Invoke the File – Save as... command
The file writing dialog appears on the screen.
3.In the dialog, expand the File type list and select the JT(*.jt) format to write.
4.Click the button Save.
The model is written to a JT format file with the same name and in the same folder as the source model file. If you want to export the model to another file, change the name of the file and its location in the standard write dialog.
|
The new setting is valid only for one write session. After writing the setting returns to the default setting or to the setting for automatic export (if available). |
Export command
Step-by-step instructions
1.Open or create a model in KOMPAS-3D (part or assembly).
2.Invoke the File — Export command.
The corresponding control elements will appear on the Parameter Panel.
3.Select the JT format from the list in the Format field.
4.Specify the name and the path to the file that will be obtained as a result of the export, in the fields File Name and Folder.
5.If necessary, load or save (after selecting objects and setting parameters) the export configuration file in the Configuration field. Configuration is a special file with a list of export parameter settings. If a configuration is loaded, it is automatically applied to export of a current document, and also to other export procedures in the current KOMPAS-3D session. More about the configuration...
6.Select the objects you need to export using the selector Source.
•To select certain types of model objects (solids, surfaces, curves, points, sketches, etc.), set the switch to The entire document and enable/disable the required options in the Objects field.
•To select model objects, set the switch to the position Selected objects. Select the desired objects in the graphic area or in the Model Tree.
The names of the selected objects will appear in the field Objects.
7.Configure the export parameters in the section Parameters. Details...
8.Run the export process. To do this, click the Save to File 
button.
9.To complete operation of the command, click the Finish 
.
