|
Checking threaded joints |
Scroll |
You can check coincidence of thread parameters in a threaded joint. To that end, the option Machining threads must be enabled on the Parameters Panel.
If the check detects inconsistency of thread parameters, a row with the table of Results A row with the collision type Thread will appear on the Parameter Panel. In cell Value, the type of error is specified. This may be:
•Depth - incorrect thread connection depth (the intersection area of the components extends beyond the thread dimensions).
•Diameter — mismatch of nominal thread diameters (for example, the bolt diameter is smaller than the hole diameter).
•Step — mismatch of thread pitches of the connected components.
•Direction — mismatch of thread directions (left-hand, right-hand) in the components of the threaded connection.
•Thread type — the thread types of the threaded connection components do not match (the error can be detected if the history of the components' construction is saved in the model).
|
If the Machining threads option is disabled, the threaded connection is displayed in the Results table with the collision type Intersection. |
