|
Coordinate Axes – Parameters |
Scroll |
Display parameters of coordinate axes for the current graphic document are configured in the Coordination Axis Display Parameters, invoked by the command Setup — Parameters... — Current drawing/fragment — Designations for construction — Coordinate axes — Parameters.
The dialog allows to select default sizes of elements of coordinate axes and select parameters of the dash dot line. For more convenience of work, explanatory figures are included into the dialog.
Controls of the dialog for setting up the parameters of coordinate axes
The element |
Description of setting |
||
1 – Jut of axis beyond start point, mm 2 – Jut of axis beyond end point, mm 3 – 4 – Bend Offset, % 5 – dash 6 – spacing |
The group of fields allows to manually enter or set – using a counter – the values of parameters for coordinate axes. |
2.2 |
|
7 - Dash |
The group of elements allows to select a variant for determination of dash length during its drawing. To make the dash length be determined automatically, enable the Length Auto Determination option. In this case, automatic calculation of such length of a hatch stroke is performed with which at the starting and ending points of axis there will be a stroke, but not a dotted line or an interval. To make the hatch stroke length not exceed some set value, enable the Length not more than, mmoption. The field for entry of a hatch stroke length will be available. Enter the maximum hatch stroke length or set it using a counter. |
2.2 |
On completion of the set-up, press the OKbutton. Click Cancel to discard all changes and close the dialog box.
