|
Measurement parameters |
Scroll |
In the Information format section, the Parameter panel displays elements that allow configuring the parameters of the measurement process. and Analysis of curves or surfaces. These elements are shown in the table.
Measurement parameters controls
The element |
Description |
|
Decimal places |
The list that defines the accuracy of the calculation results. The minimum number of decimal places is 0, the maximum number of decimal places is 9. |
|
Length units |
The list for selecting the unit of measurement for length: millimeters, centimeters, decimeters, meters. |
|
Angle units |
The list for selecting the units for measuring angles: degrees, radians. Only for commands Distance and angle and Continuity checking. |
|
Mass units |
The list for selecting the unit of measurement for mass: grams, kilograms. Only for the CMP Properties command. |
|
Briefly |
The option that allows obtaining the measurement results in a short or full form. Only for the commands Object Info, Distance and angle, CMP Properties, Mutual deviation, Curvature check. |
