|
A line with bends |
Scroll |
Setting up drawing of a line with bents for a construction drawing document is performed in the Line with bents section of setting dialog box.
To access the section, call the command Settings — Parameters... 
and in the dialog box that appears, select Current document — Break lines — A line with bends.
This section allows you to select the default amplitude, number and type of breaks, as well as to set the line overhang for the start and end points.
Controls of the jagged line setup section
Element |
Settting description |
||
Amplitude, mm |
Enter the magnitude of the amplitude of the bend. Amplitude is the distance between the line and the bend point farthest away from the line. |
2.2 |
|
Line protrusion beyond the end points, mm |
Enter the value of the line protrusion for the start and end points. |
2.2 |
|
Number of bends |
Enter an integer number of bends. |
2.1 |
|
Type of bends |
Select a bend drawing option from the list: •Type 1 — oblique symmetrical with two vertices, •Type 2 — axisymmetric with three vertices. |
2.1 |
|
If the given number of bends with the current parameters does not fit between the endpoints of the line, the maximum possible integer number of bends is drawn. |
The last column of the table shows the number of the subgroup to which the parameter to be adjusted belongs. Parameters are grouped into groups and subgroups by their effect on objects of the current document.
When you have finished configuring the parameters, click Apply and close the dialog box. To exit the dialog box without saving changes, click Cancel.
