|
Collinear |
Scroll |
Collinearity of selected objects is set by the Collinear 
command.
Step-by-step instructions
1.Specify the objects you want to set as collinear. Such objects can be segments, centerlines, auxiliary lines, break lines, straight coordinate axes.
|
When working with a drawing please note that all the parameterized objects must belong to the same view. |
If the existing constraints do not prevent parametrization of the selected objects, then these objects will be placed the following way:
•after setting two segments as collinear, they are located on the same straight line,
•after setting a segment and a straight line as collinear, the segment is located on this straight line,
•after setting two straight lines as collinear, they coincide.
The Collinear constraint is applied to objects.
2.To finish execution of the command, press Finish 
button.
Additional features for applying constraints...
The constraint Collinear may occur automatically when constructing objects in parametric mode. To do this, when setting up the parametric mode, the Snaps option must be enabled in the Parametrize list. The parametric mode is configured for a graphic document in the Parametrization section of the setup dialog, and for a sketch in a model, in the Sketch section. The constraint will be applied when dividing a segment into two or more new segments, for example, using the trimming or splitting commands.
Constraints are displayed in the graphic area in the constraint preview mode. Collinear is indicated by the icon 
.
See Also
