|
Centerline |
Scroll |
Default appearance of centerlines created with the commands Centerline by two points, Arc centerline, Auto Centerline and Center mark is configured in the Centerline section of the setting dialog box.
To access the section, call Setup — Parameters.... 
and in the dialog box that appears, select Current document — Centerline.
Controls of the Centerline settings section
Element |
Setting description |
||
Line deviation, mm Dashed line, mm Interval, mm |
The fields allow you to enter the required parameter values. |
2.2 |
|
Dash length, mm |
According to GOST, centerlines must begin and end with dashes. To fulfill this requirement, the dash lengths are changed proportionally when drawing the lines. •If the stroke length calculation must take into account the condition that the resulting value falls within the range specified by the standard (5-30 mm), select the Auto Determnation option from the list. •If you want the stroke length to not exceed a certain value (without taking into account the requirements of the standard), select the Not exceeding, mm option, and then enter the maximum length in the field on the right. |
2.2 |
|
Size of «cross», mm |
The field allows you to specify the lengths of strokes that form a crosshair in the center of the object when creating the center marking in the form of a «cross». In all other cases the length of the center strokes will be determined by the system automatically. |
2.2 |
|
The «cross» size setting also applies to the radial dimension with a bend. |
When you finish setting the parameters of drawing the centerlines, click Apply and close the dialog box. To exit the dialog box without saving the changes, click Cancel.
