|
Symbol sizes |
Scroll |
You can set the symbol sizes for the part and assembly in the Symbol sizes section of the setting dialog box.
To access the section, call the command Settings — Parameters... 
and in the dialog box that appears, select Current document— Convensional symbols — Leader — Symbol sizes.
The section allows you to set the dimensions of the circle of the marking symbols, the triangle of the stamping symbols and the height of the connection marking symbols.
Controls in the character size setting section
Element |
Setting description |
||
Diameter of marking symbol circle (according to GOST 2.314-68 10...15 mm)) |
The field allows you to specify the value of the diameter of the circle of marking symbols (in millimeters) in the document. According to GOST 2.314-68 this diameter should be from 10 to 15 mm. |
1.1 |
|
Height of the stamping symbol triangular (according to GOST 2.314-68 10...15 mm) |
The field allows to set the value of the height of triangles of stamping symbols triangles (in millimeters) in the document. According to GOST 2.314-68 this height should be from 10 to 15 mm. |
1.1 |
|
Height of designation symbols for non-detachable joints, mm |
The field allows you to set the height of the symbols to indicate joints obtained by soldering, gluing, stapling and metal brackets (in millimeters) in the document. |
1.1 |
|
If the size of the marking and stamping symbols is too small, the texts of these designations may extend beyond the symbols. To change the font in the symbols, use the dialog box for setting the text above/below/behind the leader landing (see Text above/below/behind the leader landing). |
When you have finished setting the symbol sizes, click the dialog box Apply and close. To exit the dialog box without saving changes, click Cancel.
