|
Replacing the mockup with the component |
Scroll |
Replacing the mockup with the component is performed when you configure the mockup component.
Step-by-step instructions
1.Call the relevant command for the required mockup component Component Properties 
.
2.In the Source section of the Parameter Panel set the Use mockup toggle switch into position 0 (disabled). The Mockup file field will no longer appear in the Parameter Panel.
3.Complete the setup of the mockup component's properties by clicking the Create Object 
button in the Parameter Panel header.
The assembly will display the geometry of the source component. The mockup component will become a regular component.
After replacing the mockup with the component you need to Rebuild model.
|
When you return to using the source component, the path to the mockup file is not deleted. This allows you to load this mockup again when the component is replaced with a mockup again. |
See Also
