|
Performing Corner Capping |
Scroll |
Corners in a sheet part are capped using the Corner Capping 
command.
Step-by-step instructions
1.Specify adjacent bends the corners between which you want to modify.
More details about specifying adjacent bends...
The names of the selected objects are displayed in the Corners field on the Parameter Panel. A phantom of the capped corners is displayed in the graphic area.
The controls to configure capping will appear on the Parameter Panel.
2.Set the operation parameters:
•specify the corner capping method by clicking the required button in the Capping Method group,
•specify the corner treatment methodby clicking the required button in the Corner Treatment group,
•enter a gap value in the Gap field,
•use the Continue option to indicate if matching bends adjacent to the sides of the corner to be capped need capping.
3.If required, set the name of the element and properties of its surface display using the controls located in the Properties section.
More details about managing the object color and optical properties...
4.To complete the operation, click Create Object 
.
After completing the above steps, the selected corners will be capped, and an icon of the corner capping operation will appear in the Design Tree.
5.To complete operation of the command, click Finish 
.
Tips
•To set linear parameters of the operation, you can use commands of the geometric calculator.
•You can assign a tolerance to the operation parameters expressed in linear values. To do this, run the Tolerance command located in the menu of the required parameter, or click the 
icon displayed in the parameter field (the icon is displayed if a tolerance is assigned to the parameter value).
More details about assigning tolerance...
See Also
