|
Notes on working with breaks in views |
Scroll |
•If the grid display is enabled in the graphic area of the drawing, it will not be displayed between the break borders. The snap on the grid between the break borders is impossible.
•All the dimensions, designations, captions which are present within a view with a break remain visible even if during the setup of the break they were (fully or partly) between its borders.
•Aligning dimension lines of dimensions in the view with a break may be executed incorrectly. Therefore, it is recommended to do this operation with the break disabled, or before its creation.
•The centerlines and center marks obtained using the Centerline by Two Points, Auto Centerline and Center mark, do not interrupt. If these objects were created in the document using the Segmentcommand, they will be exploded in the same way as other geometric objects.
•While adding new objects into a view with a break, or while changing the existing ones, the lines of break are not rebuilt automatically. To re-draw them with account of new image dimensions, run the View - Update Image command 
.
•The image break is a property of the drawing view. The view stores information on the position of break lines relative to the coordinate system of that view but not relative to the objects inside it. Therefore, in case of any movement of objects within a view the break lines remain at their former places. You can edit the break using the Break in View
.
If you need to reposition objects together with a break, reposition the view (see section Detailing of views on a sheet).
•If you need to delete one or more breaks from the view, invoke the View Break command, delete the name of the break(s) from the list Breaks and confirm the execution of the command.
See Also
