|
Centerline by Two Points |
Scroll |
Building a centerline by two points using the Auto Centerline is similar to executing the command Centerline by Two Points.
To build a centerline by two points, do the following actions.
1.Run the Auto-save 
command.
2.Set parameters of the centerline using elements of the Parameters sector. The setup is done the same was as the setup of rendering the designation of the center. Details...
3.In the graphic region, indicate two arbitrary points.
A centerline protruding outside the indicated points will be created automatically.
During creation of a centerline by two points, the method selected in the Tracing mode group of buttons is ignored.
|
To precisely set the position of the centerline, you can use snaps. |
4.To complete operation of the command, click Finish 
.
See Also
Centerline parallel/perpendicular to segment
Bisector of angle formed by two segments
